Clip-On Fixed Jaw with Lag Eye

The Clip-On Fixed Jaw is externally a duplicate of the Fixed Jaw and is only available for 1/8” and 3/16” diameter 1×19 stainless steel cable. 

The Clip-On Fixed Jaw was created for applications that called for factory swaged fittings on both ends of the cable, without requiring over-sized holes through the intermediate posts (so an entire Fixed Jaw could pass through). This fitting accomplishes that with a .250” diameter ferrule that is pre-swaged to the cable. Once the cable with just a ferrule swaged to it is run through the intermediate posts to the end post to which it will attach, the jaw is slipped onto the cable over the ferrule and the clip installed at the ferrule. The jaw then slides back against the clip, which prevents the fitting from coming off the cable.

This fitting attaches to the wood end post by installing a Lag Eye into a pre-drilled hole in the end post and attaching the Clip-On Fixed Jaw to the lag eye with a button head screw. Lag eye and screw sold separately.

Use of this fitting requires an appropriately sized ferrule that is swaged onto the cable, which must also be purchased separately.